Read Code - Denso BHT-1260BWB-CE User Manual

Barcode Handy Terminal/2D code Handy Terminal
Hand Held Terminal
Barcode Handy Terminal
Momentary switching mode :
Only while the trigger key is held down, the illumination LED turns on and the BHT can read a code.
The illumination LED does not turn back on by pressing the trigger key thus the BHT does not read the
next code, unless the scanned data is read out from the barcode buffer.
Alternate switching mode :
The illumination LED turns on when the trigger key is pressed, and does not turn off until the code device
file is closed or the trigger key is pressed again.
The illumination LED turns ON and OFF alternately by pressing the trigger key.
The BHT reads a code while the illumination LED is turned on, but does not read a next code until the
scanned data is read out from the code buffer.
Continuous reading mode :
The illumination LED turns on regardless of the trigger key, and turns off when the code device file is
closed.
The BHT reads a code while the illumination LED is turned on, but does not read a next code until the
scanned data is read out from the code buffer.
Trigger release mode:
The aimer* illuminates when the trigger key is pressed. When the trigger key is released, the illumination
LED turns on and the BHT starts reading a code. The BHT goes into standby state when a code is read or
after the reading time has elapsed. Aiming restarts when the trigger key is pressed again.
This mode is used to read a specific code in an area where codes are closely spaced.
* The marker functions as an aimer for the BHT equipped with the marker.
The illumination LED functions as an aimer for the BHT not equipped with the marker

4.8.3 Read Code

The Read Code menu is used to set up the
readable codes and parameters.
The codes grayed out are not available.
The parameter for each code is displayed when a
check box is checked.
BHT-1200B
BHT-1200Q
165