Denso BHT-1260BWB-CE User Manual page 89

(5) File transfer history
The login and file transfer history is displayed in the lower half of the
screen shown on the right (the area surrounded by blue lines).
If the Ftp Client Configuration needs to be changed...
To change the FTP Client Configuration,
tap the "Config..." button.
The error messages are listed below.
Message
Connection error XXXX
Server IP or Name required
User ID required
Cannot contain any of the
following characters.
The path is invalid.
The path is too long.
Filename required
The file is read only.
The file could not be found.
This file already exists.
Replace existing file?
Barcode Handy Terminal/2D code Handy Terminal
Problem
Failed to connect to the server.
Either the server IP or host name
is not specified.
Either the user ID or password is
not specified.
The folder or file name is not
correct (e.g., unsupported or very
long characters are used)
The file name is not entered.
No data can be written to the file
that is selected as the download
destination.
The selected file cannot be found.
The same file already exists.
Hand Held Terminal
Barcode Handy Terminal
Solution
Check the network environments,
server active status and FTP
settings.
Specify the server IP or host name.
Specify the user ID or password.
Specify the correct folder or file
name.
Enter the file name.
Change the read-only file to the
read-write file, or select another file.
Select an existing file name.
Select "Yes" to overwrite the file.
Select "No" not to overwrite the file,
then select another file and retry.
77