Standard Ao - ABB ACQ80-04 Firmware Manual

88 Parameters
No. Name/Value
12.101 AI1 percent value
0.00...100.00%
12.102 AI2 percent value
0.00...100.00%
13

13 Standard AO

13.02 AO force selection
Bit Value
0 1 = Force AO1 to value of parameter
1 1 = Force AO2 to value of parameter
2...15 Reserved
0b0000...0b1111
13.11 AO1 actual value
0.000...22.000 mA
13.12 AO1 source
Zero
Motor speed used
Output frequency
Motor current
Motor current % of
motor nominal
Motor torque
DC voltage
Output power
Speed ref used
Freq ref used
Process PID out
Temp sensor 1
excitation
Temp sensor 2
excitation
Abs motor speed
used
Abs motor speed %
Description
Value of analog input AI1 in percent of AI1 scaling
max - 12.17 AI1 min).
AI1 value
Value of analog input AI2 in percent of AI2 scaling
max - 12.27 AI2 min).
AI2 value
Configuration of standard analog outputs.
The source signals of the analog outputs can be overridden
for eg. testing purposes. A forced value parameter is provided
for each analog output, and its value is applied whenever the
corresponding bit in this parameter is 1.
Note: Boot and power cycle reset the force selections
(parameters 13.02 and 13.11).
Forced values selector for analog outputs AO1 and AO2.
Shows value of AO1 in mA
This parameter is read-only.
Value of AO1.
Selects a signal to be connected to analog output AO1.
None.
01.01 Motor speed used
01.06 Output frequency
01.07 Motor current (page 67).
01.08 Motor current % of motor nom
01.10 Motor torque (page 67).
01.11 DC voltage (page 67).
01.14 Output power (page 68).
28.02 Frequency ref ramp output
40.01 Process PID output actual
The output is used to feed an excitation current to the
temperature sensor 1, see parameter
source. See also section
The output is used to feed an excitation current to the
temperature sensor 2, see parameter
source. See also section
01.61 Abs motor speed used
01.62 Abs motor speed %
13.13 AO1 forced value. (0 = Normal mode)
13.23 AO2 forced value. (0 = Normal mode)
(page 67).
(page 67).
(page 67).
(page 101).
(page 130).
35.11 Temperature 1
Motor thermal protection
35.21 Temperature 2
Motor thermal protection
(page 70).
(page 70).
Def/FbEq16
(12.18 AI1 100.00
100 = 1%
(12.28 AI2 0.00
100 = 1%
0b0000
1 = 1
-
1 = 1 mA
Output
frequency
0
1
3
4
5
6
7
8
12
14
16
20
(page 44).
21
(page 44).
26
27