Start/Stop Mode - ABB ACQ80-04 Firmware Manual

No. Name/Value
13.28 AO2 source max
-32768.0...32767.0
13.29 AO2 out at AO2 src
min
0.000 ... 22.000 mA Minimum AO2 output value.
13.30 AO2 out at AO2 src
max
0.000 ... 22.000 mA Maximum AO2 output value.
13.91 AO1 data storage
-327.68...327.67
13.92 AO2 data storage
-327.68...327.67
21

21 Start/stop mode

21.01 Start mode
Fast
Description
Defines the real maximum value of the signal (selected by
parameter 13.22 AO2 source) that corresponds to the
maximum required AO2 output value (defined by parameter
13.30 AO2 out at AO2 src
source min. See parameter
AO automatic scaling.
Real signal value corresponding to maximum AO2 output
value.
Defines the minimum output value for analog output AO2.
See also drawing at parameter
Defines the maximum output value for analog output AO2.
See also drawing at parameter
Storage parameter for controlling analog output AO1 eg.
through the embedded fieldbus interface.
In parameter 13.12 AO1
Then set this parameter as the target of the incoming value
data. With the embedded fieldbus interface, simply set the
target selection parameter of that particular data
(58.101...58.114) to AO1 data
Storage parameter for AO1.
Storage parameter for controlling analog output AO2 eg.
through the embedded fieldbus interface.
In parameter 13.22 AO2
Then set this parameter as the target of the incoming value
data. With the embedded fieldbus interface, simply set the
target selection parameter of that particular data
(58.101...58.114) to AO2 data
Storage parameter for AO2.
Start and stop modes.
Selects the motor start function for the vector motor control
mode, ie. when 99.04 Motor control mode
Notes:
• The start function for the scalar motor control mode is
selected by parameter
• Starting into a rotating motor is not possible when DC
magnetizing is selected
• With permanent magnet motors,
must be used.
• This parameter cannot be changed while the drive is
running.
The drive pre-magnetizes the motor before start. The pre-
magnetizing time is determined automatically, being typically
200 ms to 2 s depending on motor size. This mode should be
selected if a high break-away torque is required.
max). See parameter 13.27 AO2
13.17 AO1 source min
13.27 AO2 source
13.27 AO2 source
source, select AO1 data
storage.
source, select AO2 data
storage.
is set to Vector.
21.19 Scalar start mode.
(Fast or Const time).
Automatic start mode
Parameters 93
Def/FbEq16
3.2 A
about the
1 = 1
0.000 mA
min.
1000 = 1 mA
20.000 mA
min.
1000 = 1 mA
0.00
storage.
100 = 1
0.00
storage.
100 = 1
Automatic
0