Id Run Procedure - ABB ACQ80-04 Firmware Manual



ID run procedure

WARNING!
speed during the ID run. The motor will rotate in the forward direction. Make
sure that it is safe to run the motor before performing the ID run!
De-couple the motor from the driven equipment
Check that the values of the motor data parameters are equivalent to those on the motor
nameplate.
Check that the STO circuit is closed.
If parameter values (from group
before the ID run, check that the new settings meet the following conditions:
Parameter 30.11 Minimum speed
Parameter 30.12 Maximum speed
the motor to be run at 100% speed.)
Parameter 30.20 Maximum torque 1
Make sure that the panel is in local control (text Local shown at the top left).
Press key
Loc/Rem
Navigate to Main menu
parameter list
select the required ID run type.
Press (OK)
Panel LED starts blinking green to indicate an
active warning (AFF6).
You can hide the warning view by pressing
(Back).
Press the start key
Note: In general, it is recommended not to press
any control panel keys during the ID run.
However, you can stop the ID run at any time by
pressing the stop key
During the ID run the arrow rotates at the top.
After the ID run is completed, the arrow stops
rotating and the rpm turns to 0.00.
If the ID run fails, fault
more information, see chapter
page 197.
Note: You must repeat the ID run procedure if
you have changed the motor parameters
Motor data) after the ID run was competed.
Pre-check
The motor will run at up to approximately 50...80% of the nominal
10 Standard DI, RO
< 0 rpm
= motor rated speed (Normal ID run procedure needs
> 50%
to switch between local and remote control modes.
ID run
→ Complete
→ parameter 99.13 and
( )
to start the ID run.
( )
.
FF61 ID run is shown. For
Fault tracing
Start-up, control with I/O and ID run 25
to group 99 Motor
99.13
Max
[0]
[1]
[2]
99.13
Max
[0]
[1]
[2]
Rem
on
Rem
(99
data) are changed
Warning: AFF6
1304rpm
1304
rpm
0.0rpm
0.00
rpm