Start Stop Control - ABB ACQ80-04 Firmware Manual

No. Name/Value
58.103 Data I/O 3
58.104 Data I/O 4
58.105 Data I/O 5
58.106 Data I/O 6
58.107 Data I/O 7
... ...
58.114 Data I/O 14
79

79 Start stop control

79.01 Solar status word1
Bit Name
0 Ready ON
1 Ready run
2 Running
3 Fault
4 Dry run
5 DC over volt
6 DC under volt
7 Minimum speed
8 Short circuit
9 Earth fault
10 Motor phase loss 1 = Motor phase missing. 0 = No motor circuit fault.
11 Supply phase loss 1 = Intermediate circuit DC voltage is oscillating due to missing input
12 Motor stall
13 Over current
14 Ext fault1
15 Start delay active 1 = Start delay alarm active.
0b0000...0b1111
79.02 Solar status word2
Description
Defines the address in the drive which the Modbus master
accesses when it reads from or writes to register address
400003.
For the selections, see parameter
Defines the address in the drive which the Modbus master
accesses when it reads from or writes to register address
400004.
For the selections, see parameter
Defines the address in the drive which the Modbus master
accesses when it reads from or writes to register address
400005.
For the selections, see parameter
Defines the address in the drive which the Modbus master
accesses when it reads from or writes to register address
400006.
For the selections, see parameter
Parameter selector for Modbus register address 400007.
For the selections, see parameter
...
Parameter selector for Modbus register address 400014.
For the selections, see parameter
Start/stop enable signal source selection; positive/negative
reference enable signal source selection. See also chapter
Start-Stop control (page 33).
Solar status word 1.
This parameter is read-only.
Description
1 = Ready to switch on.
1 = Operation enabled.
1 = Drive is modulating.
1 = Drive in fault state.
1 = Dry run detected.
1 = Excessive intermediate circuit DC voltage detected.
1 = Insufficient intermediate circuit DC voltage.
1 = Minimum speed alarm active.
1 = Short circuit in motor cables or motor, or internal fault in the drive
earth (ground) fault in motor or motor cable.
power line phase or blown fuse.
1 = Motor is operating in stall region due to excessive load
or insufficient motor power.
1 = Output current exceeds trips level.
1= External fault 1.
Solar status word 1.
Solar status word 2.
This parameter is read-only.
Parameters 155
58.101 Data I/O 1.
58.101 Data I/O 1.
58.101 Data I/O 1.
58.101 Data I/O 1.
58.101 Data I/O 1.
58.101 Data I/O 1.
Def/FbEq16
Ref2 16bit
SW 16bit
Act1 16bit
Act2 16bit
None
...
None
0b0000
1 = 1
0b0000