User Parameter Sets; User Lock - ABB ACQ80-04 Firmware Manual

52 Program features


User parameter sets

The drive supports four user parameter sets that can be saved to the permanent
memory and recalled using drive parameters. It is also possible to use digital inputs to
switch between user parameter sets. To change a user parameter set, make sure the
drive is not modulating.
A user parameter set contains all editable values in parameter groups 10...99 except
the following:
• forced I/O values such as parameters
forced data
• I/O extension module settings (group 15)
• fieldbus communication settings (groups 50...53 and 58)
• parameter 95.01 Supply
As the motor settings are included in the user parameter sets, make sure the settings
correspond to the motor used in the application before recalling a user set. In an
application where different motors are used with the drive, perform the motor ID run
with each motor and the save the results in different user sets. The appropriate set
can then be recalled when the motor is switched on.
Settings
Parameters 96.10...96.13


User lock

For better cyber security, it is highly recommended that you set a master pass code to
prevent changing of parameter values and/or the loading of firmware and other files.
WARNING! ABB will not be liable for damages or losses caused by the failure
to activate the user lock using a new pass code. See
(page 15).
To activate the user lock for the first time, enter the default pass code, 10000000, into
96.02 Pass code. This will make parameters
new pass code into
Confirm user pass
want to prevent (we recommend you select all the actions unless otherwise required
by the application).
To close the user lock, enter an invalid pass code into
96.08 Control board
96.100...96.102 are hidden.
To reopen the lock, enter your pass code into
parameters 96.102...96.102
voltage.
(page 167).
96.100 Change user pass
code. In 96.102 User lock
boot, or cycle the power. With the lock closed, parameters
visible.
10.03 DI force selection
Cybersecurity disclaimer
96.100...96.102
code, and confirm the code in
functionality, define the actions that you
96.02 Pass
96.02 Pass code. This will again make
and 10.04 DI
visible. Then enter a
96.101
code, activate