ABB ACQ80-04 Firmware Manual page 21

Navigate to the Options menu
frequency/speed reference. Use
the value.
Press (OK) to accept the new setting, or press
(Back) to go back to the previous view without making
changes.
Note: References can be provided only in local mode. In
remote mode, fieldbus speed reference can be provided
only if parameter 79.40 MPPT reference
When MPPT reference is enabled in remote mode, drive
calculates the speed/frequency reference internally. For
information on MPPT, see section
page 34.
Press Start .
Make sure that the motor is running in the required direction. The direction symbol is
displayed in the home page.
indicates forward direction
indicates reverse direction.
Press Stop .
If you want to make a backup of the settings, navigate to
Main menu and select Backup
and back up the data between drive and panel.
Select the option and press
(Back) to go back to the previous view without
making changes.
The first start setup is complete and the drive is ready for
use. The home view Shows values of selected signals.
Macro/start-stop reference, and limit settings
You can make any additional changes to the macro, ramp, and limits, if required.
Macro settings
Navigate to the Main menu
connection .
Select the desired macro. Use
cursor left and right.
Press (OK) to accept or press
back to the previous view without making changes.
Notes:
• Changing the macro resets all settings to the default values of the selected macro and
updates the I/O signals used in the drive.
You can see the currently used I/O signals in the
Start-up, control with I/O and ID run 21
and set the
and to change
is disabled.
MPPT functionality
. You can restore
(OK) to accept or press
2 – Additional settings
and select I/O
and to move the
(Back) to go
0.0Hz
0
on
Loc
I
0.00
Hz
menu.
0
10.0 Hz
PID