ABB ACQ80-04 Firmware Manual page 169

No. Name/Value
96.16 Unit selection
Bit Name
0 Power unit
1 Reserved
2 Temperature
unit
3 Reserved
4 Torque unit
5...15 Reserved
0b0000...0b1111
96.20 Time sync primary
source
Internal
Fieldbus A
Embedded FB
Panel link
Ethernet tool link
96.51 Clear fault and
event logger
0...1
96.100 Change user pass
code
10000000...
99999999
96.101 Confirm user pass
code
10000000...
99999999
Description
Selects the unit of parameters indicating power, temperature
and torque.
Information
0 = kW
1 = hp
0 = °C
1 = °F
0 = Nm (N·m)
1 = lbft (lb·ft)
Unit selection word.
Defines the 1st priority external source for synchronization of
the drive's time and date.
No external source selected.
Fieldbus interface A.
Embedded fieldbus interface.
Control panel, or Drive composer PC tool connected to the
control panel.
Drive composer PC tool through an FENA module.
Clears all events from the drive's fault and event logs.
(Visible when user lock is open)
To change the current user pass code, enter a new code into
this parameter as well as
warning will be active until the new pass code is confirmed.
To cancel changing the pass code, close the user lock without
confirming. To close the lock, enter an invalid pass code in
parameter 96.02 Pass code, activate parameter
Control board boot, or cycle the power.
See also section User lock
New user pass code.
(Visible when user lock is open)
Confirms the new user pass code entered in
user pass code.
Confirmation of new user pass code.
96.101 Confirm user pass
96.08
(page 52).
96.100 Change
Parameters 169
Def/FbEq16
0b0000
1 = 1
Panel link
0
3
6
8
9
0
1 = 1
10000000
code. A
-
-