Motor Data - ABB ACQ80-04 Firmware Manual

174 Parameters
No. Name/Value
98.09 Rs user SI
0.00000...100.0000
0 ohm
98.10 Rr user SI
0.00000...100.0000
0 ohm
98.11 Lm user SI
0.00...100000.00
mH
98.12 SigmaL user SI
0.00...100000.00
mH
98.13 Ld user SI
0.00 ...100000.00
mH
98.14 Lq user SI
0.00 ...100000.00
mH
99

99 Motor data

99.03 Motor type
Asynchronous
motor
Permanent magnet
motor
99.04 Motor control mode
Vector
Description
Defines the stator resistance R
Stator resistance.
Defines the rotor resistance R
Rotor resistance.
Defines the main inductance L
Main inductance. Rev D: 98.11-14 Partoolissa 0.1 = 1 mH.
Range upper limit on the panel ends with.0.02?
Defines the leakage inductance
Leakage inductance.
Defines the direct axis (synchronous) inductance.
Note: This parameter is valid only for permanent magnet
motors.
Direct axis inductance.
Defines the quadrature axis (synchronous) inductance.
Note: This parameter is valid only for permanent magnet
motors.
Quadrature axis inductance.
Motor configuration settings.
Selects the motor type.
Note: This parameter cannot be changed while the drive is
running.
Standard squirrel cage AC induction motor (asynchronous
induction motor).
Permanent magnet motor. Three-phase AC synchronous
motor with permanent magnet rotor and sinusoidal BackEMF
voltage.
Note: With permanent magnet motors special attention must
be paid on setting the motor nominal values correctly in
parameter group 99 Motor
If the nominal BackEMF voltage of the motor is not available,
a full ID run should be performed for improving performance.
Selects the motor control mode.
Vector control. Vector control has better accuracy than scalar
control but cannot be used in all situations (see selection
Scalar below).
Requires motor identification run (ID run). See parameter
99.13 ID run requested.
Note: In vector control the drive performs a standstill ID run at
the first start if ID run has not been previously performed. A
new start command is required after standstill ID run.
Note: To achieve a better motor control performance, you can
perform a normal ID run without load.
See also section Operating modes of the drive
of the motor model.
S
of the motor model.
R
of the motor model.
M
σ
L .
S
data. You must use vector control.
(page 31).
Def/FbEq16
0.00000 ohm
-
0.00000 ohm
-
0.00 mH
1 = 10000
mH
0.00 mH
1 = 10000
mH
0.00 mH
1 = 10000
mH
0.00 mH
1 = 10000
mH
Asynchro-
nous motor
0
1
Scalar
0