ABB ACQ80-04 Firmware Manual page 22

22 Start-up, control with I/O and ID run
Start, stop, and reference values
If you do not wish to use a macro, navigate to Main menu
Parameter group
→
Notes:
• References can be provided only in local mode. In remote mode, fieldbus speed
reference can be provided only if parameter
MPPT reference is enabled in remote mode, drive calculates the speed/frequency
reference internally. For information on MPPT, see section
34.
• Changing the start, stop, and reference settings, changes the I/O signals used in the
drive. You can see the currently used I/O signals in the
• Make sure the used I/O connections match with the actual I/O wiring. See
macros on page 55.
Limit settings
Navigate to Main menu
Limits and change the parameters to the required values. For example, maximum speed,
minimum frequency, maximum frequency and maximum current.
After making the changes, press
previous view without making changes.
After the additional changes, make sure the used I/O connections match with the actual I/O
wiring. See Control macros
To see the currently used I/O signals, navigate to Main menu
status .
Use and to check the values.
After the additional adjustments and I/O connection
validation, navigate to Main menu
Diagnostics
→
functioning correctly.
The Diagnostics menu shows active faults
history , active warnings
79 and manually define the settings for start, stop and reference.
→ Complete parameter list
OK to accept or press
3 – I/O menu
on page 55.
4 – Diagnostics menu
and make sure the setup is
, fault
, and I/O status
→ Complete parameter list
79.40 MPPT reference
MPPT functionality
menu.
Parameter group
→
(Back) to go back to the
→I/O menu
0 DI1
0 DI2
0 DI3
0
0
.
is disabled. When
on page
Control
30
→I/O