ABB ACQ80-04 Firmware Manual page 104

104 Parameters
No. Name/Value
30.13 Minimum frequency
-500.00...500.00
Hz
30.14 Maximum
frequency
-500.00...500.00
Hz
30.17 Maximum current
0.00...3.24 A
30.19 Minimum torque 1
-1600.0...0.0%
30.20 Maximum torque 1
0.0...1600.0%
30.31 Undervoltage
control
Disable
Enable
30.35 Thermal current
limitation
Disable
Enable
Description
Defines the minimum allowed frequency.
WARNING! This value must not be higher than
Maximum frequency.
WARNING! in frequency control mode only.
Minimum frequency.
Defines the maximum allowed frequency.
WARNING! This value must not be lower than
Minimum frequency.
WARNING! In frequency control mode only.
Maximum frequency.
Defines the maximum allowed drive current.
Maximum drive current.
Defines a minimum torque limit for the drive (in percent of
nominal motor torque).
Minimum torque limit 1.
Defines a maximum torque limit for the drive (in percent of
nominal motor torque).
Maximum torque 1.
Enables the undervoltage control of the intermediate DC link.
If the DC voltage drops due to input power cut off, the
undervoltage controller will automatically decrease the motor
torque in order to keep the voltage above the lower limit. By
decreasing the motor torque, the inertia of the load will cause
regeneration back to the drive, keeping the DC link charged
and preventing an undervoltage trip until the motor coasts to
a stop. This will act as a power-loss ride-through functionality
in systems with high inertia, such as a centrifuge or a fan.
Undervoltage control disabled.
Undervoltage control enabled.
Enables/disables temperature-based output current limitation.
The limitation should only be disabled if required by the
application.
Thermal current limitation disabled.
Thermal current limitation enabled.
Def/FbEq16
-300.00 Hz
30.14
10 = 1
300.00 Hz
30.13
10 = 1
3.24 A
1 = 1 A
-300.0%
10 = 1
300.0%
10 = 1
Enable
0
1
Enable
0
1