ABB ACQ80-04 Firmware Manual page 132

132 Parameters
No. Name/Value
Motor
potentiometer
Freq in scaled
AI1 percent
AI2 percent
Control panel (ref
saved)
Control panel (ref
copied)
FB A ref1
FB A ref2
EFB ref1
EFB ref2
Setpoint data
storage
Other
40.24 Set 1 internal
setpoint 0
-200000.00...
200000.00
40.26 Set 1 setpoint min
-200000.00...
200000.00
40.27 Set 1 setpoint max
-200000.00...
200000.00
40.28 Set 1 setpoint
increase time
0.0...1800.0 s
Description
Not applicable.
11.39 Freq in 1 scaled value
12.101 AI1 percent value
12.102 AI2 percent value
Panel reference (03.01 Panel
by the control system for the location where the control
returns is used as the reference.
Reference
Ext1 -> Ext2
Panel reference (03.01 Panel
previous control location is used as the reference when the
control location changes if the references for the two
locations are of the same type (eg
frequency/speed/torque/PID); otherwise, the actual signal is
used as the new reference.
Reference
Ext1 -> Ext2
03.05 FB A reference 1
03.06 FB A reference 2
03.09 EFB reference 1 (see page 71).
03.10 EFB reference 2 (see page 71).
40.92 Setpoint data storage
Source selection (see Terms and abbreviations
Internal process setpoint 1. See parameter
setpoint 1 source.
Internal process setpoint 1.
Defines a minimum limit for the process PID controller
setpoint.
Minimum limit for process PID controller setpoint.
Defines a maximum limit for the process PID controller
setpoint.
Maximum limit for process PID controller setpoint.
Defines the minimum time it takes for the setpoint to increase
from 0% to 100%.
Setpoint increase time.
(see page 83).
(see page 88)
(see page 88)
reference, see page 70) saved
Ext1 reference
Ext2 reference
Active reference
Inactive reference
t
reference, see page 70) for the
Ext1 reference
Ext2 reference
Active reference
Inactive reference
t
(see page 70).
(see page 70).
(see page 139)
40.16 Set 1
Def/FbEq16
10
11
12
13
14
15
16
19
20
24
on page 64). -
0.00
1 = 1
0.00
1 = 1
200000.00
1 = 1
0.0 s
1 = 1