ABB ACQ80-04 Firmware Manual page 144

144 Parameters
No. Name/Value
Fault always
Warning
50.03 FBA A comm loss t
out
0.3...6553.5 s
50.04 FBA A ref1 type
Speed or frequency Type and scaling is chosen automatically according to the
Transparent
General
Torque
Speed
Frequency
50.05 FBA A ref2 type
50.06 FBA A SW sel
Auto
Transparent mode
50.07 FBA A actual 1 type
Speed or frequency Type and scaling is chosen automatically according to the
Transparent
General
Description
Drive trips on 7510 FBA A
though no control is expected from the fieldbus.
Drive generates an A7C1 FBA A communication
This occurs even though no control is expected from the
fieldbus.
WARNING! Make sure that it is safe to continue
operation in case of a communication break.
Defines the time delay before the action defined by parameter
50.02 FBA A comm loss func
the communication link fails to update the message.
Time delay.
Selects the type and scaling of reference 1 received from
fieldbus adapter A. The scaling of the reference is defined by
parameters 46.01...46.04, depending on which reference
type is selected by this parameter.
Note: Applicable only when
disabled. If parameter MPPT reference is enabled, then the
parameter should be set to it's default value.
currently active operation mode as follows:
Operation mode
Speed control
Frequency control
No scaling is applied.
Generic reference without a specific unit.
The scaling is defined by parameter
The scaling is defined by parameter
The scaling is defined by parameter
Not applicable
Selects the source of the Status word to be sent to the
fieldbus network through fieldbus adapter A.
Source of the Status word is chosen automatically.
The source selected by parameter
transparent source is transmitted as the Status word to the
fieldbus network through fieldbus adapter A.
Selects the type and scaling of actual value 1 transmitted to
the fieldbus network through fieldbus adapter A. The scaling
of the value is defined by parameters 99.09, 99.08,
46.04 depending on which actual value type is selected by
this parameter.
currently active operation mode as follows.
Motor control mode
(see par. 99.04)
Speed control
Frequency control
No scaling is applied.
Generic reference without a specific unit.
communication. This occurs even
warning.
is taken. Time count starts when
79.40 MPPT reference
Reference 1 type
Speed
Frequency
46.03 Torque
46.01 Speed scaling.
46.02 Frequency
50.09 FBA A SW
Actual 1 type
Speed
Frequency
Def/FbEq16
4
5
0.3 s
1 = 1 s
Speed or
frequency
is
0
1
2
scaling. 3
4
scaling. 5
Auto
0
1
Speed or
frequency
46.03 and
0
1
2