Emerson E300 Series Design Manual page 46

Safety Product Mechanical
information information installation
Figure 3-24 Installation of high IP insert for size 4
1. To install the high IP insert, firstly place a flat head screwdriver into the slot highlighted (1).
2. Pull the hinged baffle up to expose the ventilation hole, install the high IP insert into the ventilation hole in the heatsink (2).
3. Ensure the high IP insert is securely installed by firmly pressing it into place (3).
4. Close the hinged baffle as shown (1).
To remove the high IP insert, reverse the above instructions.
The guidelines in Table 3-6 should be followed.
46
Electrical Getting
User Menu A Commissioning
installation started
Advanced
Diagnostics Optimization CT MODBUS RTU Technical Data
Parameters
E300 Design Guide
Issue Number: 1