This indicates the profile generator output speed in mm/s units. The profile generator output speed is based on the profile specified in menu G-Profile

parameters.

RFC-A and RFC-S mode Actual speed

This parameter indicates the actual speed of the motor in mm/s units. In closed loop operation the actual speed is based upon the encoder feedback

and motor rated speed mm/s and rpm scaling.

A07 {J59}

Output Power

Num

RFC-A

+ VM_POWER kW

RFC-S

A07 (Output Power J59)

The Output power is the power flowing via the AC terminals of the drive. The power is derived as the dot product of the output voltage and current

vectors, and is therefore correct even if the motor parameters are incorrect and the motor model does not align the reference frame with the flux axis

of a motor in RFC-A mode. For Open loop, RFC-A and RFC-S modes a positive value of power indicates power flowing from the drive to motor.

A08 {J60}

Output Frequency

Num

+ VM_SPEED_FREQ _

REF Hz

RFC-A

+ 550.0 Hz

RFC-S

A08 (Output Frequency J60)

The Output frequency in Open loop mode is the sum of the post ramp reference and the motor slip compensation frequency. In Closed loop operation

the output frequency is not controlled directly and the output frequency is a measurement of the frequency applied to the motor.