Emerson E300 Series Design Manual page 286

Safety Product Mechanical
information information installation
F74 Motor Thermistor Input Select
Mode Open-Loop, RFC-A, RFC-S
Minimum 0
Default
Type 16 Bit User Save
Display Format Standard
Coding RW
When set to 0, a thermistor input is not selected, and T8 Analog Input 3 Mode (F52) is set to Volt or 6.
When set to 1, analog input 3 thermistor input is selected, and T8 Analog Input 3 Mode (F52) is set to Therm No Trip or 9. T8 Analog Input 3
Thermistor Type (F59), T8 Analog Input 3 Thermistor Trip Threshold (F60) and T8 Analog Input 3 Thermistor Reset Threshold (F61) are used to
configure the thermistor input.
When set to 2, the drive encoder thermistor input is selected, and T8 Analog Input 3 Mode (F52) is set to Volt or 6. Encoder Thermistor Type (F69),
Encoder Thermistor Trip Threshold (F70) and Encoder Thermistor Reset Threshold (F71) are used to configure the thermistor input.
286
Electrical Getting
User Menu A Commissioning
installation started
Advanced
Diagnostics Optimization CT MODBUS RTU Technical Data
Parameters
Maximum 2
Units
Update Rate Background
Decimal Places 0
E300 Design Guide
Issue Number: 1