Emerson E300 Series Design Manual page 373

Safety Product Mechanical
information information installation
K06
Mode
Minimum
Default
Type
Display Format
Coding
Setting Logic Function 1 Output Invert (K06) inverts the output of logic function 1.
K07
Mode
Minimum
Default
Type
Display Format
Coding
Logic Function 1 Delay (K07) defines the delay at the output of logic function 1. If Logic Function 1 Delay (K07) is positive then the output does not
become 1 until the input to the delay has been at 1 for the delay time. If Logic Function 1 Delay (K07) is negative then the output remains at 1 until the
input to the delay has been 0 for the delay time.
K08
Mode
Minimum
Default
Type
Display Format
Coding
Logic Function 1 Destination (K08) defines the output destination of logic function 1.
E300 Design Guide
Issue Number: 1
Electrical Getting
User Menu A Commissioning
installation started
Logic Function 1 Output Invert
Open-Loop, RFC-A, RFC-S
0
0
1 Bit User Save
Standard
RW
Logic Function 1 Delay
Open-Loop, RFC-A, RFC-S
-25.0
0.0
16 Bit User Save
Standard
RW
Delay parameter> 0
Delay parameter< 0
Logic Function 1 Destination
Open-Loop, RFC-A, RFC-S
A00
A00
16 Bit User Save
Menu Param Alpha Numeric
RW, DE, PT, BU
Advanced
Parameters
Maximum
Units
Update Rate
Decimal Places
Maximum
Units
Update Rate
Decimal Places
Logic function delay
Maximum
Units
Update Rate
Decimal Places
Diagnostics Optimization CT MODBUS RTU Technical Data
1
4 ms read
0
25.0
s
4 ms read
1
Delay input
Delay output
Delay input
Delay output
AB99
Drive reset read
3
373