Safety
Product
Mechanical
information
information
installation
A grommet kit is available for size 7 finger guards.
Table 3-1 Grommet kit (size 7)
Drive size
Size 7 - Kit of 8 x single entry grommets
3.4
Installing / removing option modules, keypad
Power down the drive before installing / removing the option module. Failure to do so may result in damage to the product.
CAUTION
Figure 3-4 Installation of a standard option module
NOTE
Option module slots must be used in the following order: slot 3, slot 2 and slot 1
Installing the first option module
•
Move the option module in direction shown (1).
•
Align and insert the option module tab in to the slot provided (2), this is highlighted in the detailed view (A).
•
Press down on the option module until it clicks into place.
32
Electrical
Getting
User Menu A Commissioning
installation
started
Advanced
Diagnostics Optimization CT MODBUS RTU Technical Data
Parameters
Part number
3470-0086-00
Picture
E300 Design Guide
Issue Number: 1