Emerson E300 Series Design Manual page 176

Safety Product Mechanical
information information installation
Table 7-35 UPS power control parameter
Parameter
Ups Control Enable (O05)
UPS Maximum Power Set point
(O06)
UPS evacuation current full load
limit (O07)
UPS evacuation current no load
limit (O08)
Figure 7-22 Emergency power supply backup control
Output power
O06
UPS maximum
power setpoint
Standard
speed
selection
DC Bus voltage
Symmetrical
current limit
176
Electrical Getting
User Menu A
installation started
Enable, disable for UPS control
Maximum UPS power in kW. This setting prevents the UPS from being overloaded during emergency evacuation
with UPS control enable = On (1).
Defines the percentage full load current allowed during emergency evacuation with UPS control enable = On (1)
to prevent overloading, and to extend the operating time of the UPS power supply.
Defines the percentage no load current allowed during emergency evacuation with UPS control enable = On (1)
to prevent overloading, and to extend the operating time of the UPS power supply.
J58
0
B16 I-max %
Current full
load O07
Current no
J64
load O08
450 V
1
B16
0
Symmetrical current
limit stored value
O05
UPS control
enable
Advanced
Commissioning
Parameters
Detail
1
1
0
0
DC Bus
J64
550 V
1
0
O05
UPS control
enable
Diagnostics Optimization CT MODBUS RTU Technical Data
J38
Active speed
setpoint
B16
Symmetrical
current limit
E300 Design Guide
Issue Number: 1