Suzuki WagonR+ RB310 Service Manual page 2650

2
3
REASSEMBLY
CAUTION:
New oilless bearing have been lubricated when they are
supplied as spare parts. DO NOT wash with grease dissolv-
ing solvent nor lubricate them with other lubricant.
1) Apply grease (Refer to page 6G-5).
2) Install armature to yoke.
3) Install brushes (1) and brush springs (2) to brush holder (3).
4) Install brush holder to armature while pushing 4 brushes out-
ward.
5) Install new rear armature shaft bush.
6) Install rear bracket (1) to brush holder (2).
7) Tighten brush holder screws (3).
8) Install over-running clutch (1), pinion stop ring (2) and snap ring
(3) to gear shaft (4).
NOTE:
Care for installing direction of pinion stop ring.
9) Set pinion stop ring at the position as shown.
10) Install new front armature shaft bush to front housing.
11) Insert shaft assembly (1) into front housing (2) with lever (3)
positioned as shown.
CRANKING SYSTEM 6G-13