Suzuki WagonR+ RB310 Service Manual page 2513

6A1-38 ENGINE MECHANICAL
D Indicates position from timing
belt side. Install in numerical or-
der starting from timing belt
side.
D Indicates direction of housing.
Install so that arrow is directed
toward timing belt side.
6) Apply engine oil to cams and journals on camshaft and put cam-
shaft on cylinder head. Install camshaft housing to camshaft and
cylinder head.
D Apply engine oil to sliding surface of each housing against
camshaft journal.
D Apply sealant to mating surface of No.6 housing (1) which will
mate with cylinder head.
"A" Sealant: 99000-31110
A: Timing belt side
B: Flywheel side
D Embossed marks are provided on each camshaft housing, in-
dicating position and direction for installation.
Install housings as indicated by these marks.
D As camshaft housing No.1 retains camshaft in proper position
as to thrust direction, make sure to first fit No.1 housing to No.1
journal of camshaft securely.
D After applying engine oil to housing bolts, tighten them tempo-
rarily first. Then tighten them by following sequence as indi-
cated in figure.
Tighten a little at a time and evenly among bolts and repeat
tightening sequence two to three times before they are tight-
ened to specified torque.
Tightening Torque
(a): 11 N
7) Install camshaft oil seal (1).
After applying engine oil to oil seal lip, press-fit camshaft oil seal
till oil seal surface becomes flush with housing surface.
8) Install timing belt inside cover (1).
.
m (1.1 kg-m, 8.0 lb-ft)