Suzuki WagonR+ RB310 Service Manual page 2188

Power steering Manual steering
REMOVAL
1) Disconnect negative battery cable at battery terminal.
2) Disable air bag system. Refer to "Disabling Air Bag System"
under "Precautions" earlier in this section.
3) Remove steering wheel and contact coil cable assembly. Refer
to "Steering Wheel" and "Contact Coil Cable Assembly" earlier
in this section.
4) Detach turn & dimmer switch assembly and wiper switch as-
sembly from steering column.
5) Remove ignition switch cylinder assembly (1) as follows.
a) Turn ignition switch key to "ACC" position.
b) Insert 2 mm (0.078 in.) rod (2) through hole (3) and push
ignition switch cylinder lock.
5-1) Remove immobilizer control module (4) from steering column.
6) Detach ignition switch assembly (1) from steering column.
7) Disconnect connectors from electrical power steering system
parts if equipped.
8) Remove steering shaft upper joint bolt (1).
9) Remove steering column mounting nuts (1).
10) Remove steering column from vehicle.
WARNING:
Never rest a steering column assembly on the steering
wheel with the air bag (inflator) module face down and
column vertical. Otherwise, personal injury may result.
STEERING WHEEL AND COLUMN 3C-15