Suzuki WagonR+ RB310 Service Manual page 2712

INPUT SHAFT ASSEMBLY
DISASSEMBLY
1) Remove input shaft right bearing (2) from input shaft (1) by using
bearing puller (3) and press.
2) Drive out 5th gear spacer (2), left bearing (3) and 4th gear (4) all
at once from input shaft (1) by using puller (5) and press.
CAUTION:
To avoid gear tooth from being damaged, support it at flat
side of bearing puller.
3) Take out 4th gear needle bearing and high speed synchronizer
ring.
4) Using circlip pliers, remove circlip (1).
5) Drive out high speed synchronizer sleeve & hub assembly (2)
together with 3rd gear (3) from input shaft (1) by using puller (4)
and press.
CAUTION:
Make sure to use flat side of puller to avoid causing dam-
age to 3rd gear tooth.
6) Take out 3rd gear needle bearing from shaft.
7) Disassemble synchronizer sleeve & hub assembly.
MANUAL TRANSMISSION 7A-21