Suzuki WagonR+ RB310 Service Manual page 2229

3E-16 REAR SUSPENSION
6) Clean mating surface of rear axle (right & left) with brake back
plate and apply water tight sealant as shown in figure.
"A": Sealant 99000-31090
7) Install brake back plates (1) and tighten back plate bolts (2) to
specified torque.
Tightening Torque
.
(a): 23 N m (2.3 kg-m, 16.5 lb-ft)
8) Connect wheel speed sensor and lead wire clamps (right & left)
(if equipped).
CAUTION:
Since there are two holes on each side of rear axle, be
sure to install wheel speed sensor at the position as
shown in figure.
9) Connect brake pipes to wheel cylinders (1) (right & left) and
tighten brake pipe flare nuts (2) to specified torque.
Tightening Torque
.
(b): 16 N m (1.6 kg-m, 11.5 lb-ft)
10) Connect brake flexible hoses (1) (right & left) to bracket on rear
axle and secure it with E-rings (2) (right & left).