Suzuki WagonR+ RB310 Service Manual page 2801

7B-70 AUTOMATIC TRANSMISSION (4 A / T)
2. Bolt A
3. Bolt B
4. Bolt C
12) Disconnect couplers from solenoid valves, and A/T fluid tem-
perature sensor.
Remove A/T fluid temperature sensor.
13) Remove valve body assembly (1).
CAUTION:
Be careful not to let manual valve fall off when removing
valve body assembly.
NOTE:
There are three kinds of bolts (bolts A, B and C) fixing
valve body ass'y.
14) Remove solenoid harness assembly.
15) Remove accumulator pistons and springs.
To remove C0 (1), C2 (2) and B1 (3) accumulator pistons and
springs, position a rag on pistons to catch each piston.
To remove pistons, force low-pressure compressed air (1 kg/cm
15 psi, 100 kPa, max) into hole (4) as shown in figure, and pop
each piston into the rag.
To remove B0 and C1 accumulator pistons and springs, re-
move each snap ring and accumulator spacer, then remove
spring and piston.
NOTE:
Do not push accumulator pistons with fingers or anything
before removing them. Pushing them may cause com-
pressed fluid in accumulator to spew out of hole and get
to your face and clothes.
2
,