DTC P1614 INCORRECT SIGNAL FROM IMMOBILIZER
DTC DETECTING CONDITION AND TROUBLE AREA
DTC DETECTING CONDITION
Signal from immobilizer control module is not
matched.
TROUBLE SHOOTING (DTC P1614)
STEP
1
Proceed DTC FLOW TABLE of DTC B3061.
Recheck DTC.
Is DTC P1614 still output?
DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE
1) Turn ignition switch to (I) or ( ) position.
2) Leave it for 5 seconds or more.
3) Check DTC. Refer to DTC CHECK in this section.
ACTION
IMMOBILIZER CONTROL SYSTEM 8G-21
TROUBLE AREA
Ignition key with built-in transponder internally faulty
SKC is not registered in transponder
SKC key is not registered in ECM
SKCs are different between ECM and transponder
Unregistered ignition key with built-in transponder
FIX CODE is detected
No FIX CODE in immobilizer control module
YES
Substitute a known-
good ECM according
to PROCEDURE FOR
ECM REPLACEMENT
and recheck.
NO
ECM and immobilizer
control module are
programmed
correctly.