Suzuki WagonR+ RB310 Service Manual page 2619

6E-32 ENGINE AND EMISSION CONTROL SYSTEM
MAIN RELAY, FUEL PUMP RELAY AND RADIATOR
FAN CONTROL RELAY
Inspection
1) Disconnect negative cable at battery.
2) Remove main relay (1), fuel pump relay (2) and radiator fan con-
trol relay (3) from vehicle.
3) Check that there is no continuity between terminal "c" and "d".
If there is continuity, replace relay.
4) Connect battery positive (+) terminal to terminal "b" of relay.
Connect battery negative (–) terminal "a" of relay.
Check continuity between terminal "c" and "d".
If there is no continuity when relay is connected to the battery,
replace relay.
FUEL CUT OPERATION
Inspection
NOTE:
Before inspection, check to make sure that gear shift lever is
in neutral position (with A/T model, selector lever in "P"
range), A/C is OFF and that parking brake lever is pulled all the
way up.
1) Warm up engine to normal operating temperature.
2) While listening to sound of injector (1) by using sound scope (2)
or such, increase engine speed to higher than 3,000 r/min.
3) Check to make sure that sound to indicate operation of injector
stops when throttle valve is closed instantly and it is heard again
when engine speed is reduced to less than about 2,000 r/min.