5E1-30 ANTILOCK BRAKE SYSTEM (ABS)
2
REMOVAL
1) Disconnect negative cable from battery.
2) For LH vehicle, remove air cleaner outlet pipe (1) referring to
"Engine Mechanical" section.
3) Disconnect ABS hydraulic unit/control module assembly con-
nector (1) by pulling up lock (2).
4) Using special tool, loosen flare nuts (1) and disconnect brake
pipes (2) from ABS hydraulic unit/control module assembly (3).
Special Tool
09950-78220
NOTE:
Put bleeder plug cap onto pipe to prevent fluid from spilling.
Do not allow brake fluid to get on painted surfaces.
5) Remove two nuts and disconnect take out ABS hydraulic
unit/control module assembly (1) from bracket using screwdriv-
er (2).
CAUTION:
D Do not give an impact to hydraulic unit.
D Use care not to allow dust to enter hydraulic unit.
D Do not place hydraulic unit on its side or upside down.
Handling it in inappropriate way will affect its original
performance.