Flushing Brake Hydraulic System - Suzuki WagonR+ RB310 Service Manual

FLUSHING BRAKE HYDRAULIC SYSTEM

It is recommended that entire hydraulic system be thoroughly
flushed with clean brake fluid whenever new parts are installed in
hydraulic system.
Periodical change of brake fluid is also recommended.
FLUID PRESSURE TEST (if equipped with
LSPV)
Test procedure for LSPV assembly is as follows.
Before testing, confirm the following.
D Fuel tank is filled with fuel fully.
D Vehicle is equipped with spare tire, tools, jack and jack handle.
1) Stop vehicle on level floor and place approximately about
1,000 N (100 kg, 220 lbs) weight (1) on rear housing so that rear
axle weighs 4,500 N (450 kg, 992 lbs).
Rear axle weight "L": 4,500 N (450 kg, 992 lbs)
2) Install special tool to front and rear brake.
NOTE:
Pressure gauge should be connected to bleeder plug hole
of front (left side brake) and rear (right side brake).
After testing front left side and rear right side, test front
right side and rear left side in the same way.
Special Tool
Front brake
(A): 09956-02310
(B): 09952-36310
(C): 55473-82030 (Air bleeder plug as a spare part)
1
NOTE:
For front brake, use special tool (B) instead of thread diame-
"L"
ter 10 mm attachment included in special tool (A).
Rear brake
(A): 09956-02310
(C): 55473-82030 (Air bleeder plug as a spare part)
(D): 09952-48320
BRAKES 5-13