Suzuki WagonR+ RB310 Service Manual page 2820

6) Install snap ring (1).
NOTE:
Make sure that the ends of the snap ring do not come to the
opening of the input shaft subass'y.
7) Place special tool (C) on soft jawed vise (2) with wider opening
(1) facing up.
Special Tool
(C): 09926-26040
8) Place rear clutch assembly (1) on special tool (C).
9) Set dial gauge (2) on the top of clutch flange (3) and measure
clearance by blowing compressed air (4 kg/cm
shown in figure.
Clearance: 0.80 – 1.40 mm (0.031 – 0.055 in.)
If the clearance is out of specification, replace clutch discs,
plates and flange.
AUTOMATIC TRANSMISSION (4 A / T) 7B-89
2
, 57 psi) as