Suzuki WagonR+ RB310 Service Manual page 2999

9-38 BODY SERVICE
CRANK DRIVE
REMOVAL
1) Close sliding roof glass.
2) Remove sliding roof handle (1) and remove sliding roof handle
garnish (2).
3) Loosen crank drive screws (3) and then remove crank drive (4).
INSPECTION
D Check that the crank drive operates smoothly.
D Check crack and deformation for pinion gear (1) and drive lock pin
(2).
If replace as necessary.
INSTALLATION
1) Adjust sliding roof assembly and crank drive for assemblying
position. Refer to SLIDING ROOF ASSEMBLY in this section.
2) Reverse removal procedure for installation.
D Install crank drive (1) with turned it lock pin (2) to forward direc-
tion as shown in figure.
D Tighten crank drive handle screw (1) to specified torque.
Tightening Torque: 2 N
.
m (0.2 kg-m, 1.4 lb-ft)