Suzuki WagonR+ RB310 Service Manual page 2519

6A1-44 ENGINE MECHANICAL
DISASSEMBLY
1) For ease in servicing cylinder head, remove thermostat case, in-
take manifold with throttle body and exhaust manifold from cylin-
der head.
2) Remove rocker arms and springs by pulling its shaft out to trans-
mission side.
3) Using special tool (Valve lifter), compress valve springs and then
remove valve cotters (1) by using special tool (Forceps) as
shown.
Special Tool
(A): 09916-14510
(B): 09916-14910
(C): 09916-84511
4) Release special tool, and remove spring retainer and valve
spring.
5) Remove valve from combustion chamber side.
6) Remove valve stem oil seal (1) from valve guide and then valve
spring seat (2).
NOTE:
Do not reuse oil seal once disassembled. Be sure to use
new oil seal when assembling.
7) Using special tool (Valve guide remover), drive valve guide out
from combustion chamber side to valve spring side.
Special Tool
(A): 09916-44910
NOTE:
Do not reuse valve guide once disassembled. Be sure to
use new valve guide (Oversize) when assembling.
8) Place disassembled parts except valve stem seal and valve guide
in order, so that they can be installed in their original position.