Suzuki WagonR+ RB310 Service Manual page 2836

1. Differential case
2. Differential gear
3. Differential pinion shaft
1. Differential case
2. Differential gear
3. Differential pinion shaft
2. Differential case
4) Remove side pinion shaft pin.
Use special tool and hammer for its removal.
Special Tool
(C): 09922-85811
5) Remove side pinion shaft, differential pinions with each washer,
differential gears with each washer.
ADJUSTMENT AND REASSEMBLY
Prepare replacing parts as required and proceed to reassembly.
Make sure that all parts are clean.
1) Install differential gears.
Measure and adjust thrust play referring to Section 7A.
If thrust play is out of specification, select suitable thrust washer
from among following available size, install it and check again
that specified gear play is obtained.
Available thrust
washer thickness
Then assemble them with suitable thrust washers.
2) Drive in side pinion shaft pin from right side till it is flush with diff.
case surface.
Special Tool
(C): 09922-85811
3) Install differential side L bearing (1). Press-fit it by using special
tool and copper hammer.
Special Tool
(D): 09924-74510
(E): 09926-68310
AUTOMATIC TRANSMISSION (4 A / T) 7B-105
0.9, 0.95, 1.0, 1.05, 1.1, 1.15
and 1.2 mm
(0.035, 0.037, 0.039, 0.041,
0.043, 0.045, and 0.047 in.)