STEERING KNUCKLE/BEARING
1. Wheel hub
2. Circlip
3. Wheel bearing:
Face grooved rubber seal
side to wheel hub.
4. Steering knuckle
5. Dust cover
6. Tie-rod end
7. Wheel speed sensor (if equipped)
8. Drive shaft nut:
Calk, after tightening.
9. Tie-rod end nut
REMOVAL
1) Hoist vehicle and remove wheel.
2) Uncalk drive shaft nut (1).
3) Depress foot brake pedal and hold it there. Remove drive shaft
nut.
4) Remove caliper carrier bolts.
5) Remove caliper with carrier.
NOTE:
Hang removed caliper with a wire hook of the like so as to
prevent brake hose from bending and twisting excessively
or being pulled.
Don't operate brake pedal with pads removed.
6) Pull brake disc (1) off by using two 8 mm bolts.
FRONT SUSPENSION 3D-11
10. Ball stud bolt
11. Strut bracket bolt:
Insert from the direction as shown.
12. Brake caliper carrier bolt
13. Drive shaft nut:
Calk, after tightening.
: Tightening Torque
: Do not reuse
14. Wheel hub nut
15. Brake disc