Suzuki WagonR+ RB310 Service Manual page 2958

REGISTRATION PROCEDURE OF IMMOBILIZER SYSTEM COMPONENTS
IMMOBILIZER SYSTEM COMPONENTS REGISTRATION FLOW TABLE
When replacing any component of immobilizer system, perform registration procedure according to following flow
table.
NOTE:
When replacing immobilizer control module and ECM at the same time, the ignition key with built-in trans-
ponder that has been registered to the system (SKC registered transponder) can not be used. Prepare new
ignition key with built-in transponder (SKC unregistered transponder), and perform steps 1 to 4 as follows.
STEP
1 DTC CHECK.
Check for DTC referring to DTC CHECK.
Are there DTC B1000, B3040, B3042, and/or
B3043?
2 Confirmation of password registration.
Is there DTC B3057?
3 ECM replacement.
Is ECM replaced?
4 Immobilizer control module replacement.
Is immobilizer control module replaced?
5 Ignition key with built-in transponder registration.
Is ignition key registered?
ACTION
IMMOBILIZER CONTROL SYSTEM 8G-23
YES
Proceed to each
diagnostic flow table
corresponding to that
DTC number.
Register password by
referring HOW TO
REGISTER
PASSWORD.
After completing, go to
step 3.
Proceed to
PROCEDURE AFTER
ECM REPLACEMENT.
After completing, go to
step 4.
Proceed to
PROCEDURE AFTER
IMMOBILIZER
CONTROL MODULE
REPLACEMENT.
Proceed to HOW TO
REGISTER IGNITION
KEY.
NO
Go to step 2.
Go to step 3.
Go to step 4.
Go to step 5.
End.