Suzuki WagonR+ RB310 Service Manual page 2964

2) Remove inside handle bezel (1).
3) Remove inside lock knob and door trim fitting screw.
4) Remove door trim (1).
With inside handle bezel (2) tilted as shown in figure, turn door
trim (1) 90_ counterclockwise to remove it.
And disconnect power window switch lead wire at coupler (if
equipped).
5) Remove door sealing cover (1).
6) Remove door mirror.
Refer to "DOOR MIRROR" in this section.
7) Remove glass run (1).
Lower window all the way down. Then, use a tape-wrapped
putty knife to pry off glass run.
NOTE:
When removed glass run (1) from door panel (2), be careful
not to deformation for glass run (1).
8) Remove door sash mounting bolts (1) and screws (2).
9) Remove glass attaching screws (3).
10) Take out door glass (4).
BODY SERVICE 9-3