Suzuki WagonR+ RB310 Service Manual page 2825

7B-94 AUTOMATIC TRANSMISSION (4 A / T)
6) Install snap ring (1).
NOTE:
Make sure that the ends of the snap ring do not come to the
opening of the front clutch No.1 drum.
7) Place special tool (A) on soft jawed vise (1) and install 2 oil seal
rings on special tool.
Special Tool
(A): 09926-26050
SUZUKI GENUINE PARTS
(B): Rear cover seal ring 24742-78F10
NOTE:
D Rear cover seal set has two seal rings in a set.
D Do not use the seal rings removed from rear cover. It is not
necessary to remove seal rings from special tool once
installed.
8) Place direct clutch assembly (1) on special tool (A).
9) Set dial gauge (4) on the top of clutch flange and measure clear-
ance by blowing compressed air (4kg/cm
figure.
Clearance: 0.50 – 1.04 mm (0.0197 – 0.0409 in.)
If the clearance is out of specification, replace clutch discs,
plates and flange.
2. Snap ring
3. Air gun
2
, 57 psi) as shown in