Suzuki WagonR+ RB310 Service Manual page 2210

FORWARD
1. Stabilizer bar 8. Stabilizer bar
2. Ball stud bolt
3. Knuckle 9. Washer
4. Ball stud 10. Stabilizer bar castle nut
5. Stabilizer bar 11. Suspension control
bracket bolt
6. Control arm bolt
7. Suspension
control arm 12: Split pin
SUSPENSION CONTROL ARM/BUSHING
REMOVAL
1) Hoist vehicle and remove wheel.
2) Remove split pin (12), stabilizer bar castle nut (10), washer (9)
3) Remove stabilizer bar mount bracket (right & left) bolts (5).
4) Remove ball stud bolt (2).
5) Remove suspension control arm bolt (6).
6) Remove suspension control arm (7).
10
: Tightening Torque
: Do not reuse
bushing
arm bushing:
Before installing,
apply soap water.
7) Remove bushing.
Press
and bushing (8).
Place suspension control arm onto flat surface side of special
tool and push out bushing with special tool and oil hydraulic
press as shown.
Special Tool
(A): 09943-77910
FRONT SUSPENSION 3D-17