Suzuki WagonR+ RB310 Service Manual page 2857

7B-126 AUTOMATIC TRANSMISSION (4 A / T)
2. Flange nut
3. Torque converter housing
4. Cup
63) Install A/T VSS (1) and input revolution sensor (2).
Apply grease to O-ring of each sensor.
Tightening Torque:
.
(a): 8 N m (0.8 kg-m, 6.0 lb-ft)
64) Install engine mounting LH bracket.
Tightening Torque:
.
(a): 55 N m (5.5 kg-m, 40.0 lb-ft)
65) Install breather hose (1).
66) Install shift switch (2).
Install it temporarily so that the adjustment can be done after
installing A/T ass'y back to the vehicle.
Tightening Torque:
.
(a): 18 N m (1.8 kg-m, 13.0 lb-ft)
67) Install torque converter (1) to input shaft.
D Install torque converter, using care not to damage oil seal of
oil pump.
D After installing torque converter, check to make sure that dis-
tance "a" is within specification.
Distance "a": More than 20.9 mm (0.823 in.)
D Check torque converter for smooth rotation.
D Apply grease around cup at the center of torque converter.
"C": Grease 99000-25010
CAUTION:
D Before installing converter, make sure that its pump
hub portion is free from nicks, burrs or damage
which may cause oil seal to leak.
D Be very careful not to drop converter on oil pump
gear. Damage in gear, should it occur, may cause a
critical trouble.