Suzuki WagonR+ RB310 Service Manual page 3080

1. Stretch it to full length 10m (33 ft)
2. Power source (12V vehicle battery)
3. Connect one banana plug to positive terminal of
power source (12V vehicle battery) and then the
other to negative terminal to immediately deploy.
4. Short harness leads after deployment.
5. Drop cloth, blanket or similar them.
14) Separate the two banana plugs on the deployment harness.
15) Connect the deployment harness to the power source (12 V ve-
hicle battery) to immediately deploy/activate the air bag or the
pretensioner.
16) Disconnect the deployment harness from the power source (12
V vehicle battery) and short the two deployment harness leads
together by fully seating one banana plug into the other.
17) Put on a pair of shop gloves to protect your hands from possible
irritation and heat when handling the deployed air bag (inflator)
module and the activated seat belt pretensioner.
18) Disconnect the deployment harness from the air bag (inflator)
module and the seat belt pretensioner as soon after deploy-
ment/activation as possible.
This will prevent damage to the deployment harness due to
possible contact with the hot air bag (inflator) module and seat
belt pretensioner. The deployment harness are designed to be
5
reused. They should, however, be inspected for damage after
each deployment/activation and replaced if necessary.
19) Carefully remove drop cloth from vehicle and clean off any frag-
ments or discard drop cloth entirely.
20) Repeat Steps 2) through 19) to deploy/activate air bag (inflator)
modules and seat belt pretensioners which has not been
deployed/activated, if any.
21) In the unlikely event that the air bag (inflator) module and the
seat belt pretensioner proceed immediately with Steps 23)
through 25). If the air bag (inflator) module and the seat belt
pretensioner did deploy/activate, proceed with Steps 22).
22) With air bags deployed and pretensioners activated the vehicle
may be scrapped in the same manner as a non-air bag system
equipped vehicle.
23) Remove the undeployed air bag (inflator) module(s) and the in-
activated seat belt pretensioner(s) from the vehicle. For driver
air bag (inflator) module refer to SECTION 3C, for passenger
air bag (inflator) module refer to "On-Vehicle Service" in this
section, for seat belt pretensioner refer to SECTION 10A.
24) [For air bag (inflator) module]
Temporarily store the air bag (inflator) module with its vinyl trim
cover facing up, away from the surface upon which it rests. Re-
fer to "Service Precautions" in this section for details.
[For seat belt pretensioner]
When temporarily strong the seat belt pretensioner, be sure
NOT to face its exhaust hole provided side down. It must face
up. Refer to "Service Precautions" in this section for details.
25) Contact your local distributor for further assistance.
AIR BAG SYSTEM 10B-63