Suzuki WagonR+ RB310 Service Manual page 2374

DIAGNOSTIC TROUBLE CODE (DTC)
CLEARANCE
[Using SUZUKI scan tool]
1) Connect SUZUKI scan tool (Tech-1) to data link connector in the
same manner as when making this connection for DTC check.
2) Turn ignition switch ON.
3) Erase DTC and pending DTC according to instructions dis-
played on scan tool. Refer to scan tool operator's manual for fur-
ther details.
4) After completing the clearance, turn ignition switch off and dis-
connect scan tool from data link connector.
NOTE:
DTC and freeze frame data stored in ECM memory are also
cleared in following cases. Be careful not to clear them be-
fore keeping their record.
D When power to ECM is cut off (by disconnecting battery
cable, removing fuse or disconnecting ECM connectors)
D When the same malfunction (DTC) is not detected again
during 40 engine warm-up cycles.
[Not using SUZUKI scan tool]
1) Turn the ignition switch OFF position.
2) Disconnect battery negative cable for specified time below to
erase diagnostic trouble code stored in ECM memory and re-
connect it.
Time required to erase DTC:
Ambient
temperature
Over 0_C (32_F)
Under 0_C (32_F)
ENGINE DIAGNOSIS 6-15
Time to cut power to ECM
30 sec. or longer
Not specifiable.
Select a place with higher
than 0_C (32_F) temperature.