9-14 BODY SERVICE
5) Install new molding (1) to glass (2).
6) Clean glass surface to be adhered to body with clean cloth. If
cleaning solvent is used, let it dry for more than 10 minutes.
Cleaning Area
Distance from the edge of glass
"a": 30 – 50 mm (1.18 – 1.97 in.)
7) Install new spacer (1) to glass (4).
2. Ceramic printing
3. Cutting section of
ceramic printing
8) Using new brush, apply sufficient amount of primer for glass
along glass surface to be adhered to body.
NOTE:
D Be sure to refer to maker's instruction for proper handling
and drying time.
D Do not apply primer on outside of ceramic coated surface.
D Do not touch primer coated surface.
Width "a" : 22 mm (0.87 in.)
1. Molding
2. Fastener
3. Spacer
9) Apply primer for molding along molding surface all around as
shown in figure.
"b" : 15 mm (0.59 in.)