Suzuki WagonR+ RB310 Service Manual page 2676

WITH CHARGING EQUIPMENT
CAUTION:
When jump starting engine with charging equipment, be
sure equipment used is 12-volt and negative ground. Do not
use 24-volt charging equipment. Using such equipment can
cause serious damage to electrical system or electronic
parts.
REMOVAL
1) Disconnect negative cable (1).
2) Disconnect positive cable (2).
3) Remove battery band (3).
4) Remove battery (4).
HANDLING
When handling battery, the following safety precautions should be
followed:
D Hydrogen gas is produced by battery. A flame or spark near bat-
tery may cause the gas to ignite.
D Battery fluid is highly acidic. Avoid spilling on clothing or other fab-
ric. Any spilled electrolyte should be flushed with large quantity
of water and cleaned immediately.
INSTALLATION
Reverse removal procedure for installation, and then note the fol-
lowing instruction.
D Install battery (1) to battery tray (2), and then fit "A" to "B" exactly.
D Torque battery positive (+) and negative (–) cable terminal nuts
to specification.
Tightening Torque
.
8.0 N m (0.8 kg-m, 6.0 lb-ft)
NOTE:
Check to be sure that ground cable has enough clearance to
hood panel by terminal.
CHARGING SYSTEM 6H-7