Knock Sensor - Suzuki WagonR+ RB310 Service Manual

6A1-12 ENGINE MECHANICAL

KNOCK SENSOR

REMOVAL
1) Disconnect negative cable from battery.
2) Hoist vehicle.
3) Remove intake manifold rear stiffener.
4) Disconnect knock sensor connector (1).
5) Remove knock sensor (2) from cylinder block.
INSPECTION
Check sensor for damage.
If any faulty is found, replace.
INSTALLATION
Reverse removal procedure for installation.
Tightening Torque
.
(a): 23 N m (2.3 kg-m, 16.5 lb-ft)
CYLINDER HEAD COVER
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect breather hose and PCV valve from head cover.
3) Remove suction pipe from air cleaner assembly.
4) Remove ignition coil assemblies with high-tension cord.
5) Remove cylinder head cover (1) with cylinder head cover gasket
(2) and O-rings (3).
INSTALLATION
1) Install O-rings (2) and cylinder head cover gasket (1) to cylinder
head cover (3).
NOTE:
Be sure to check each of these parts for deterioration or any
damage before installation and replace if found defective.
2) Install cylinder head cover to cylinder head and tighten cover
bolts to specified torque.
Tightening Torque
.
(a): 11 N m (1.1 kg-m, 8.0 lb-ft)
NOTE:
When installing cylinder head cover, use care so that cylin-
der head cover gasket or O-rings will not get out of place or
fall off.