Suzuki WagonR+ RB310 Service Manual page 2505

6A1-30 ENGINE MECHANICAL
2
1
1. No.1 bolts (short)
2. No.2 bolts (long)
ASSEMBLY
1) Wash, clean and then dry all disassembled parts.
2) Apply thin coat of engine oil to inner rotor (2) and outer rotor (1),
oil seal lip portion, and inside surfaces of oil pump case and
plate.
3) Install outer and inner rotors to pump case.
4) Install rotor plate. Tighten screws securely.
After installing plate, check to be sure that gears turn smoothly
by hand.
Tightening Torque
.
(a): 11 N m (1.1 kg-m, 8.0 lb-ft)
5) Apply engine oil to O-ring (1) and install O-ring and guide (2).
INSTALLATION
1) Install two oil pump pins and oil pump gasket to cylinder block.
Use a new gasket.
2) To prevent oil seal lip from being damaged or upturned when
installing oil pump to crankshaft, fit special tool (Oil seal guide)
to crankshaft, and apply engine oil to special tool.
Special Tool
(A): 09926-18210
3) Install oil pump to cylinder block.
As there are 2 types of oil pump bolts, refer to figure for their cor-
rect use and tighten them to specified torque.
Tightening Torque
.
(a): 11 N m (1.1 kg-m, 8.0 lb-ft)