Suzuki WagonR+ RB310 Service Manual page 2184

4) From the position where contact coil became unable to turn any
further (it stopped), turn it back clockwise about two and a half
rotations and align center mark with alignment mark (1).
INSTALLATION
1) Check that vehicle's front tires are at straight-ahead position and
contact coil is centered. If contact coil is turned after removing
steering wheel, center contact coil referring to "Centering Con-
tact Coil Cable Assembly" earlier in this section.
CAUTION:
These two conditions are prerequisite for installation of
steering wheel. If steering wheel has been installed with-
out these conditions, contact coil will break when steer-
ing wheel is turned.
2) Install steering wheel to steering shaft with 2 grooves (1) on con-
tact coil fitted in two lugs (2) in the back of steering wheel and
also aligning marks (3) on steering wheel and steering shaft.
3) Apply thread lock to all around thread part of steering shaft bolt
and tighten to specified torque.
"A": Thread lock 1342 99000-32050
Tightening Torque
(a): 25 N·m (2.5 kg-m, 18.5 lb-ft)
4) Install horn buttons, right (1) and left (2), and fix connector (3)
securely.
5) Install driver air bag (inflator) module to steering wheel. Refer to
"Driver Air Bag (Inflator) Module" earlier in this section.
6) Connect negative battery cable.
7) Enable air bag system. Refer to "Enabling Air Bag System" un-
der "Precautions" earlier in this section.
STEERING WHEEL AND COLUMN 3C-11