Suzuki WagonR+ RB310 Service Manual page 2906

3
ON-VEHICLE SERVICE
IGNITION (MAIN) SWITCH
INSPECTION
1) Disconnect negative cable at battery.
2) Disable air bag system. Refer to DISABLING AIR BAG SYSTEM
in Section 10B.
3) Remove steering column cover. Refer to step 5) of CONTACT
COIL CABLE ASSEMBLY REMOVAL in Section 3C.
4) Disconnect ignition (main) switch coupler as follows.
a) Turn ignition switch key to "ACC" position.
b) Insert screw driver (1) through coupler hole.
c) Unlock coupler lock (2) by pushing it in arrow direction with
screw driver (1).
d) With unlocked, disconnect ignition (main) switch coupler (3).
5) Check continuity between terminals at each switch position. If
continuity is not obtained according to the table below, replace
ignition (main) switch (4).
Terminal
Key Position
OUT
LOCK LOCK
ACC ACC
IN
ON ON
ST ST
4
REMOVAL
1) Remove ignition switch cylinder assembly. Refer to step 5) of
STEERING COLUMN REMOVAL in Section 3C.
2) Remove ignition (main) switch from steering column.
INSTRUMENTATION / DRIVER INFORMATION 8C-5
+B +B +ACC +ACC IG1 IG1 IG2 IG2 ST ST