Suzuki WagonR+ RB310 Service Manual page 2155

3B1-14 ELECTRICAL POWER STEERING (EPS) SYSTEM (IF EQUIPPED)
Condition between diagnosis switch
terminal and ground terminal
Within 10 seconds
Open
Ground
"a": about 1 second
DTC CLEARANCE
USING SUZUKI SCAN TOOL
1) Turn ignition switch to OFF position.
2) After setting cartridge to SUZUKI scan tool, connect scan tool to
data link connector (DLC) (1) located on underside of instrument
panel at driver's seat side.
Special Tool
(A): 09931-76011
(B): Mass storage cartridge
(C): 09931-76030
3) Turn ignition switch to ON position.
4) Erase DTC according to instructions displayed on SUZUKI scan
tool referring to "SUZUKI SCAN TOOL OPERATOR'S MANU-
AL" for further details.
5) After completing the check, turn ignition switch to OFF position
and disconnect SUZUKI scan tool from DLC.
NOT USING SUZUKI SCAN TOOL
1) Turn ignition switch to ON position.
2) Using service wire, repeat shorting and opening between diag-
nosis output terminal (1) and ground terminal (2) on monitor cou-
pler (3) at least 5 times at about 1 second intervals within 10 se-
conds.