2
3) Insert flat tip screwdriver (1) between stator core (2) and front
housing (3), and then separate generator into front and rear
sides.
4) Loosen pulley nut (1) using vise (2) and take off pulley (3).
NOTE:
D When using vise, put clean cloth (4) between rotor (5) and
vise so as not to cause damage to rotor.
D Be sure to hold the location "A". Do not hold the location
"B" as it does not have enough structural strength.
5) Remove rotor from front housing.
6) When removing front bearing, remove bearing retainer screws
(1) and retainer.
CHARGING SYSTEM 6H-15